LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> TrailBlazer RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder Fluid Level Sensor >> Installation

Master Cylinder Fluid Level Sensor: Installation

  1. Using a pair of needle nose pliers, compress the snap ring (1). See Fig 1 .
    2. NOTE: Ensure that the fluid sensor is fully seated before releasing the snap ring.
  2. Install the fluid sensor in the master cylinder.
  3. Release the snap ring and remove the needle nose pliers.
    Fig 1: Snap Ring Removal
    G00083425Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals