Park Brake Cable Automatic Adjuster: Disabling
- Place the park brake lever in the full release position.
- Raise and suitably support the vehicle.
- Pull the park brake cable equalizer toward the rear of the vehicle and place a locking plier with protected jaws on the cable to hold the cable in an extended position.
- Lower the vehicle.
- Rotate the self-adjust clip into the lock position with a flat bladed tool.
- Raise the vehicle.
- Remove the locking plier from the park brake cable.
- Lower the vehicle.
- Partially raise the park brake lever, stopping prior to the self-adjust clip activating on the mount bracket tab.
- Insert a flat bladed tool behind the self-adjust clip and twist the tool 90 degrees to raise the self-adjust clip over the mount bracket tab.
- Raise the handle until it is fully applied and remove the screwdriver.