Installation Procedure

If installing a new trim plate, perform the following steps:
1. If equipped, install the cigar lighter or 12-volt power supply outlets. Refer to Cigar Lighter Housing or 12 Volt Accessory Power Receptacle Replacement .
2. Install the rear windshield wiper switch. Refer to WIPER/WASHER SWITCH REPLACEMENT - REAR in Wiper/Washer Systems.
3. If equipped, install the transfer case shift control switch. Refer to TRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT (GMC, BUICK) or TRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT (CHEVROLET) .
Connect the electrical connectors as necessary.
Install the trim plate to the IP. Ensure that all of the retaining clips are properly seated.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the lower trim plate retaining screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).

Fig 1: Removing/Installing Instrument Panel (I/P) Accessory Trim Plate & Retaining Screws
Courtesy of GENERAL MOTORS CORP.
Install the center closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower (GMC/Chevrolet) .
Install the center console. Refer to Console Replacement .