Removal Procedure
- Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Oldsmobile) .
- Remove the lower trim plate retaining screws.
- Starting at the bottom of the trim plate, release the 2 lower retaining clips and the 2 intermediate retaining clips.
- Release the 3 upper retaining clips.
- Disconnect the electrical connectors as necessary.
- If replacing the trim plate, perform the following steps:
- Remove the rear windshield wiper switch. Refer to WIPER/WASHER SWITCH REPLACEMENT - REAR in Wiper/Washer Systems.
- If equipped, remove the cigar lighter and 12-volt power supply. Refer to Cigar Lighter Housing or 12 Volt Accessory Power Receptacle Replacement .