LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> TrailBlazer 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Instrument Panel Cluster (IPC) Replacement >> Installation Procedure

Installation Procedure

  1. Position the IPC to the IP.
  2. Connect the electrical connector to the IPC.
  3. Install the IPC to the IP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the screws to the instrument panel cluster.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

    Fig 1: Removing/Installing Instrument Panel Cluster (IPC) & Retaining Screws
    GM692029Courtesy of GENERAL MOTORS CORP.
  5. Install the instrument panel (IP) accessory trim plate, GMC or Oldsmobile only. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory (Chevrolet)  or Trim Plate Replacement - Instrument Panel (I/P) Accessory (Oldsmobile) .
  6. Install the instrument panel cluster (IPC) bezel, Chevrolet only. Refer to Bezel Replacement - Instrument Panel (I/P) Cluster (Chevrolet)  or Bezel Replacement - Instrument Panel (I/P) Cluster (GMC/Oldsmobile) .
  7. Install the knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster .
  8. Install the left closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Left .
  9. If installing a new IPC. Refer to Instrument Panel Cluster (IPC) Programming/Synchronization .
scientia non olet · About LEMON Manuals