LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> TrailBlazer 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Closeout/Insulator Panel Replacement - Right >> Installation Procedure

Installation Procedure

  1. Install the insulator panel to the vehicle, positioning the insulator panel to the IP.
    Fig 1: Removing/Installing Closeout/Insulator Panel Retaining Screws
    GM712812Courtesy of GENERAL MOTORS CORP.
  2. Install the electrical connector retaining clip to the back side of the insulator panel if equipped.
  3. Insert the insulator panel retaining tab into the cowl slot.
  4. Seat the insulator panel retaining clip to the IP substrate.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the 2 insulator panel retaining screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals