Removal Procedure

Remove the 12-volt power supply or cigar lighter fuse.
Remove the socket by placing one side of the "T" portion of the tool J 42059 into the socket and into the square window tab. See Special Tools and Equipment .

Fig 1: Removing Cigar Lighter Socket With J 42059
Courtesy of GENERAL MOTORS CORP.
Position the opposite "T" portion of the tool into the opposing square window tab.
Pull the socket straight out of the retaining ring.

Fig 2: Removing/Installing Socket Out Of Retaining Ring
Courtesy of GENERAL MOTORS CORP.
Remove the tool from the socket.
Disconnect the electrical connector from the socket.

Fig 3: Disconnecting/Connecting Socket Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Using your finger, remove the socket retaining ring by pulling the retaining ring out of the mounting hole.

Fig 4: Removing/Installing Socket Retaining Ring
Courtesy of GENERAL MOTORS CORP.