LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, RWD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Drum Brake Adjusting Hardware >> Removal & Installation

Removal & Installation

  1. Remove the brake drum. See BRAKE DRUMS  .
  2. Remove the brake shoe hold-down pins in order to release the brake shoe hold-down springs. See Figure .
  3. Remove the brake shoe hold-down springs.
  4. Remove the following components:
    • The Adjuster
    • The Adjuster Lever
    • The Adjuster Spring. See Figure .
  5. To install, apply Lubriplate(R) Lubricant, (1050109 US; 5264008 Canada), or the equivalent white lithium grease, to all of the brake component metal contact points (where the brake shoe metal contacts the backing plate, the wheel cylinder, the adjustment strut, etc.) prior to installation.
  6. Install the following components:
    • The Adjuster
    • The Adjuster Lever
    • The Adjuster Spring. See Figure .
  7. Install the brake shoe hold-down springs. See Figure . Turn the brake shoe hold-down pins in order to secure the brake shoe hold-down springs.
  8. Install the brake drum.
scientia non olet · About LEMON Manuals