LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, RWD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Driver's Knee Bolster Panel
    GM477550Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the IP drivers knee bolster panel (2 or 3). Secure the panel with the 4 bolts (1 or 4).

    Tighten:  Tighten the knee bolster panel bolts to 20 N.m (15 lb ft).

    2. Fig 2: Installing IP Steering Column Opening Trim Plate
    GM477508Courtesy of GENERAL MOTORS CORP.
  2. Install the IP steering column opening trim plate (1) to the instrument panel. Secure the trim plate with the 3 screws (2).
scientia non olet · About LEMON Manuals