Installation Procedure

Fig 1: Installing IP Wiring Harness To IP Reinforcement

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .

Install the IP reinforcement to the IP assembly. Secure the reinforcement with the following:
1. The 10 screws
2. The 4 bolts
  Tighten: Tighten the IP reinforcement bolts to 23 N.m (17 lb ft).
Install the IP wiring harness (2) to the IP reinforcement (1). Secure the harness with the plastic retainers.

Fig 2: Installing Left Side Mounting Screw Rear Of IP Assembly

Courtesy of GENERAL MOTORS CORP.

Install the screw (3) to the left side of the rear of the IP assembly (1) which secures the IP wiring harness (2).

Fig 3: Installing Center Mounting Screw Rear Of IP Assembly

Courtesy of GENERAL MOTORS CORP.

Install the 2 screws (1) to the center of the rear of the instrument panel (3) which secure the IP wiring harness (2).

Fig 4: Installing Right Side Mounting Screw Rear Of IP Assembly

Courtesy of GENERAL MOTORS CORP.

Install the screw (3) to the right side of the rear of the IP assembly (1) which secures the IP wiring harness (2).

Fig 5: Installing Heater Duct

Courtesy of GENERAL MOTORS CORP.

Install the heater duct to the IP assembly
Install the windshield defroster outlet duct (2) to the IP assembly Secure the outlet duct with the 4 screws (1).

Fig 6: Installing Air Distribution Center Duct To IP Assembly

Courtesy of GENERAL MOTORS CORP.

Install the air distribution center duct (1) to the IP assembly. Secure the center duct with the screw (2).
Install the IP assembly. Refer to Instrument Panel (I/P) Assembly Replacement .