Removal Procedure

Fig 1: Releasing Instrument Cluster Bezel Assembly Tabs

Courtesy of GENERAL MOTORS CORP.

Remove the instrument cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
Remove the instrument cluster lens and bezel assembly (2) from the instrument cluster (1) by releasing the 6 black plastic tabs.

Fig 2: Removing Fuel/Temperature Gauge

Courtesy of GENERAL MOTORS CORP.

NOTE: Do not remove the needle from the fuel or temperature gages. There is no detent or flat spot on the shaft in order to indicate the correct placement.

Remove the following components from the instrument cluster (2):
1. The 6 screws (5)
2. The fuel/temperature gage