LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, 4WD, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder >> Removal

Master Cylinder: Removal

  1. Disconnect the reservoir fluid level connector. See Figure .
  2. Clean the reservoir and the master cylinder.
  3. Remove the reservoir cap. See Fig 1 .
  4. Remove the reservoir diaphragm.
  5. Remove the fluid with a syringe.
  6. Remove the reservoir screw, or remove the reservoir pin using a drift.
  7. Remove the reservoir.
  8. On models equipped with ABS, disconnect the brake pipes from the proportioning valve. See Fig 2 .
  9. On all models, disconnect the brake pipes from the master cylinder.
  10. Remove the nuts that retain the master cylinder to the brake booster.
  11. Remove master cylinder from brake booster.
Fig 1: Removing/Installing Reservoir From Master Cylinder
G00284632Courtesy of GENERAL MOTORS CORP.
Fig 2: Disconnecting Brake Pipes From Proportioning Valve
G00284643Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals