LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, 4WD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Instrument Panel (I/P) Carrier Support Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing Air Distribution Center Duct Mounting Screw
    GM477520Courtesy of GENERAL MOTORS CORP.
  1. Remove the instrument panel assembly. Refer to Instrument Panel (I/P) Assembly Replacement .
  2. Remove the following components from the IP assembly:
    1. The screw (2)
    2. The air distribution center duct (1)
    3. Fig 2: Removing Heater Duct & Defroster Outlet Duct
    GM477521Courtesy of GENERAL MOTORS CORP.
  3. Remove the following components from the IP assembly:
    1. The 4 screws (1)
    2. The windshield defroster outlet duct (2)
    3. The heater duct
    4. Fig 3: Removing Left Side Mounting Screw Rear Of IP Wiring Harness
    GM477526Courtesy of GENERAL MOTORS CORP.
  4. Remove the screw (3) from the left side of the rear of the IP assembly (1) which secures the IP wiring harness (2).
    5. Fig 4: Removing Center Mounting Screw Rear Of IP Wiring Harness
    GM477525Courtesy of GENERAL MOTORS CORP.
  5. Remove the 2 screws (1) from the center of the rear of the IP assembly (3) which secure the IP wiring harness (2).
    6. Fig 5: Removing Right Side Mounting Screw Rear Of IP Wiring Harness
    GM477526Courtesy of GENERAL MOTORS CORP.
  6. Remove the screw (3) from the right side of the rear of the IP assembly (1) which secures the IP wiring harness (2).
    7. Fig 6: Removing IP Wiring Harness From IP Reinforcement
    GM477522Courtesy of GENERAL MOTORS CORP.
  7. Release the wiring harness retainers and remove the IP wiring harness (2) from the IP reinforcement (1).
  8. Remove the following components from the IP assembly:
    1. The 10 screws
    2. The 4 bolts
    3. The IP reinforcement
scientia non olet · About LEMON Manuals