LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, 4WD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Instrument Cluster Printed Circuit Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing Instrument Cluster Bulb Sockets
    GM478155Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable.
  2. Remove the instrument cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
  3. Remove all of the bulb sockets from the rear of the instrument cluster (2).
  4. Remove the following from the rear of the instrument cluster (2):
    1. The multifunction alarm retainer
    2. The multifunction alarm (1)
  5. Remove the anti-lock brake indicator check module (6) from the rear of the instrument cluster (2).
    6. Fig 2: Releasing Instrument Cluster Bezel Assembly From Instrument Cluster
    GM478152Courtesy of GENERAL MOTORS CORP.
  6. Remove the instrument cluster lens and bezel assembly (2) from the instrument cluster (1) by releasing the 6 black plastic tabs.
  7. Remove the engine tachometer from the instrument cluster. Refer to Tachometer Replacement .
  8. Remove the speedometer from the instrument cluster. Refer to Speedometer Replacement .
  9. Remove the fuel/temperature gage from the instrument cluster. Refer to Fuel/Temperature Gage Replacement .
    10. Fig 3: Removing Instrument Cluster Printed Circuit
    GM478157Courtesy of GENERAL MOTORS CORP.
  10. Remove the instrument cluster printed circuit (2) from the instrument cluster (1).
scientia non olet · About LEMON Manuals