LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Tracker 2D Utility, 4WD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Instrument Cluster Printed Circuit Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Instrument Cluster Printed Circuit
    GM478157Courtesy of GENERAL MOTORS CORP.
  1. Install the instrument cluster printed circuit (2) to the instrument cluster (1).
  2. Install the anti-lock brake indicator check module (6) to the rear of the instrument cluster (2).
  3. Install the multifunction alarm (1) to the rear of the instrument cluster (2). Secure the alarm with the retainer.
    4. Fig 2: Installing Bulb Sockets To Instrument Cluster Assembly
    GM478155Courtesy of GENERAL MOTORS CORP.
  4. Install all of the bulb sockets to the rear of the instrument cluster assembly (2).
  5. Install the engine tachometer to the instrument cluster. Refer to Tachometer Replacement .
  6. Install the speedometer to the instrument cluster. Refer to Speedometer Replacement .
  7. Install the fuel/temperature gage to the instrument cluster. Refer to Fuel/Temperature Gage Replacement .
    8. Fig 3: Engaging Instrument Cluster Bezel Assembly From Instrument Cluster
    GM478152Courtesy of GENERAL MOTORS CORP.
  8. Install the instrument cluster lens and bezel assembly (2) to the instrument cluster (1). Ensure that the plastic retaining tabs are fully engaged.
  9. Install the instrument cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals