Engine Oil Pressure Indicator Always On
Engine Oil Pressure Indicator Always On
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you review the Instrument Panel Cluster (IPC) Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Symptoms - Instrument Panel, Gages and Console |
| 2 | Verify that the engine oil indicator is inoperative. Does the engine oil indicator operate normally? |
Go to TESTING FOR INTERMITTENT AND POOR CONNECTIONS | Go to Step 3 |
| 3 | Disconnect the oil pressure switch connector. Does the oil pressure indicator remain lit? |
Go to Step 4 | Go to Step 5 |
| 4 | Repair the short to ground in the YEL/BLK wire or the instrument panel cluster printed circuit. Did you complete the repair? |
Go to Step 7 | - |
| 5 | Test the oil pressure with a mechanical gage. Is the oil pressure normal? |
Go to Step 6 | Go to Oil Pressure Diagnosis and Testing in Engine Mechanical - 2.0L |
| 6 | Replace the oil pressure switch. Did you complete the repair? |
Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |