Chime Inoperative

Step	Action	Yes	No
Schematic Reference: WARNING SYSTEMS
1	Did you review the Audible Warning Description and Operation and perform the necessary inspections?	Go to Step 2	Go to Symptoms - Instrument Panel, Gages and Console
2	Verify that the chime is inoperative. Does the system operate normally?	Go to TESTING FOR INTERMITTENT AND POOR CONNECTIONS	Go to Step 3
3	Disconnect the audio alarm module connector. Turn the ignition switch to ON. Connect a test lamp from the audio alarm module connector cavity 7 to B+. Does the test lamp illuminate?	Go to Step 5	Go to Step 4
4	Use a test lamp in order to backprobe the junction block connector C4 from cavity 16 to B+. Does the test lamp illuminate?	Go to Step 7	Go to Step 6
5	With the audio alarm module still disconnected and the ignition switch turned to ON, connect a test lamp from cavity 5 of the audio alarm module to ground. Does the test lamp illuminate?	Go to Step 9	Go to Step 8
6	Inspect for a poor ground connection at the junction block. If the connection is OK, replace the junction block. Is the repair complete?	Go to Step 10	-
7	Repair the open in the BLK wire between the junction block and the audio alarm module. Is the repair complete?	Go to Step 10	-
8	Repair the open BLK/WHT wire between cavity 5 of the audio alarm module connector and junction block Connector C4 cavity 3. Is the repair complete?	Go to Step 10	-
9	Replace the audio alarm module. Refer to Multifunction Alarm Module Replacement . Is the repair complete?	Go to Step 10	-
10	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3