Inflatable Restraint Passenger Presence System Replacement - Front

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint Passenger Presence System - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the seat cushion cover. Refer to Front Seat Cushion Cover and Pad Replacement (without KA1) or Front Seat Cushion Cover and Pad Replacement (with KA1) .
1	Inflatable Restraint Front Passenger Presence System Assembly WARNING: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. WARNING: To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction. Procedures Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .

Callout

Component Name

Preliminary Procedure

Remove the front seat. Refer to Front Seat Replacement - Bucket .
Remove the seat cushion cover. Refer to Front Seat Cushion Cover and Pad Replacement (without KA1) or Front Seat Cushion Cover and Pad Replacement (with KA1) .

Inflatable Restraint Front Passenger Presence System Assembly

WARNING: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

WARNING: To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction.

Procedures

Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed.
Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .