LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes (Cab & Chassis, & Hd) >> Removal & Installation >> Park Brake Drum >> Removal

Park Brake Drum: Removal

  1. Release the park brake.
  2. Raise the vehicle and support the vehicle with safety stands.
  3. Reference mark the center bearing to the crossmember. See Fig 1 .
  4. Remove the nuts, washers, and bolts from the center bearing.
  5. Remove the bolts and the universal joint retainers from the transmission yoke. See Fig 2 .
  6. Reference mark the front propeller shaft to the transmission yoke.
  7. Remove the front propeller shaft from the transmission yoke.
  8. Tape the bearing cups to the universal joint to prevent the loss of the needle bearings.
  9. Position the front propeller shaft to provide access to the park brake drum.
  10. Remove the park brake drum to transmission yoke bolts.
  11. Remove the park brake drum.
Fig 1: Marking Center Bearing To Crossmember
G00317541Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Universal Joint Retainers
G00317542Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals