Installation Procedure
- Lubricate the brake caliper mounting bracket bushings and the caliper slide pins with high temperature silicone brake lubricant
- Install the caliper slide pin boots (4) to the disc brake caliper mounting bracket
- Install the caliper slide pins (5) to the brake caliper mounting bracket (3).
- Install the disc brake pad retainers to the brake caliper mounting bracket
- Install the disc brake pads to the brake caliper mounting bracket
- Install the disc brake caliper to the brake caliper mounting bracket. Refer to Rear Brake Caliper Replacement (1500 Series) or Rear Brake Caliper Replacement (2500/3500 Series)
- With the engine OFF, gradually apply the brake pedal approximately 2/3 of it's travel distance
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 7-8 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads
- Replace wheel and tire assembly. Lower the vehicle