LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Prizm Base, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Repair Instructions - Disc >> Brake Caliper Replacement >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  3. Remove the brake hose union bolt (1). Place a container beneath the brake hose in order to catch escaping brake fluid.
  4. Disconnect the brake hose.
    Fig 1: Removing Brake Hose Union Bolt
    G01711119Courtesy of GENERAL MOTORS CORP.
  5. Remove the 2 caliper pin bolts (1).
    6. Fig 2: Removing 2 Caliper Pin Bolts
    G01711120Courtesy of GENERAL MOTORS CORP.
  6. Remove the caliper from caliper bracket.
  7. Inspect the following components for corrosion and wear. Replace any part if necessary:
    • The mounting bolts
    • The caliper pins
    • The dust boots
  8. Remove the brake pads, insulators, retainers, and the wear indicator from the caliper housing. Refer to Brake Pads Replacement .
scientia non olet · About LEMON Manuals