LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Prizm Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Trim Panel Replacement - Knee Bolster >> Installation Procedure

Installation Procedure

  1. Install the hood latch release handle to the IP drivers knee bolster trim, if removed.
  2. Install the OBD II data link connector (1) to the knee bolster trim (2).
    Fig 1: Installing OBD II Data Link Connector To Knee Bolster Trim
    G01639958Courtesy of GENERAL MOTORS CORP.
  3. Connect the hood latch release cable (1) to the hood latch release handle.
    Fig 2: Connecting Hood Latch Release Cable
    G01639959Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  4. Install knee bolster trim (1) to the instrument panel assembly. Secure the trim with the 2 bolts (3).
    Fig 3: Installing Knee Bolster Trim To Instrument Panel Assembly
    G01639960Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the knee bolster trim bolts to 10 N.m (89 lb in).

  5. Install the left body hinge pillar trim panel. Refer to TRIM REPLACEMENT -- HINGE PILLAR .
scientia non olet · About LEMON Manuals