Installation Procedure

NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Install the I/P reinforcement (3) to the vehicle. Secure the reinforcement with the following fasteners:
- The 4 bolts
- The 4 nuts
  Tighten
  
  Tighten the instrument panel reinforcement bolts and nuts to 28 N.m (21 lb ft).
  
  Fig 1: Installing I/P Reinforcement
  Courtesy of GENERAL MOTORS CORP.
Install the radio antenna extension cable to the instrument panel reinforcement (1). Secure the cable with the plastic retainers (2).
Install the brake pedal return spring.
Install the windshield defroster nozzle duct to the heater case assembly.
Install the I/P center support braces. Refer to BRACKET REPLACEMENT - IP Center Support .

Fig 2: Installing Radio Antenna Extension Cable To Instrument Panel Reinforcement
Courtesy of GENERAL MOTORS CORP.