LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Prizm Base, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Fuel/Rear Compartment Release Handle Housing Replacement >> Removal Procedure

Removal Procedure

  1. Remove the left body hinge pillar trim panel. Refer to TRIM REPLACEMENT -- HINGE PILLAR .
  2. Unclip and remove the left front side door sill trim plate (1).
    Fig 1: Unclipping Removing Left Front Side Door Sill Trim Plate
    G01639942Courtesy of GENERAL MOTORS CORP.
  3. Remove the following components from the vehicle:
    • The 2 retainers (4)
    • The footrest (5)
    Fig 2: Removing 2 Retainers And Footrest
    G01639943Courtesy of GENERAL MOTORS CORP.
  4. Remove the front floor front console. Refer to CONSOLE REPLACEMENT - Front Floor .
  5. Remove the plastic retainer (3) which secures the floor panel carpet to the bulkhead.
  6. Remove the 2 plastic retainers (2) which secure the floor panel carpet to the left I/P center support brace (1).
    7. Fig 3: Removing 2 Plastic Retainers Securing Floor Panel Carpet
    G01639944Courtesy of GENERAL MOTORS CORP.
  7. Remove the left front seat assembly. Refer to SEAT REPLACEMENT -- FRONT BUCKET in Seats.
  8. Position the floor panel carpet back in order to the access the fuel/rear compartment release handle housing.
  9. Remove the left rear floor air outlet duct from the vehicle.
  10. Remove the following components from the floor panel:
    • The mounting bolt
    • The fuel/rear compartment release handle housing
  11. Remove the following components from the housing:
    • The fuel filler door lock release cable
    • The rear compartment lid lock release cable
  12. Remove the fuel/rear compartment release handle housing from the vehicle.
scientia non olet · About LEMON Manuals