LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Prizm Base, Automatic, A245E/MS7 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel, Gauges & Console >> Repair Instructions >> Fuel/Rear Compartment Release Handle Housing Replacement >> Installation Procedure

Installation Procedure

  1. Install the following components to the fuel/rear compartment release handle housing:
    • The fuel filler door lock release cable
    • The rear compartment lid lock release cable
      NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the fuel/rear compartment release handle housing to the floor panel. Secure the housing with the mounting bolt.

    Tighten 

    Tighten the fuel/rear compartment release handle housing mounting bolt to 10 N.m (89 lb in).

  3. Install the left rear floor air outlet duct to the vehicle.
  4. Reposition the floor panel carpet back to its original position.
  5. Install the left front seat assembly. Refer to SEAT REPLACEMENT -- FRONT BUCKET in Seats.
  6. Install the 2 plastic retainers (2) which secure the floor panel carpet to the left I/P center support brace (1).
    Fig 1: Installing 2 Plastic Retainers Securing Floor Panel Carpet
    G01639945Courtesy of GENERAL MOTORS CORP.
  7. Install the plastic retainer (3) which secures the floor panel carpet to the bulkhead.
  8. Install the front floor front console. Refer to CONSOLE REPLACEMENT - Front Floor .
  9. Install the footrest (5) to the vehicle. Secure the footrest with the 2 plastic retainers (4).
    10. Fig 2: Installing Footrest To Vehicle
    G01639946Courtesy of GENERAL MOTORS CORP.
  10. Install the left front side door sill trim plate (1).
    11. Fig 3: Installing Left Front Side Door Sill Trim Plate
    G01639947Courtesy of GENERAL MOTORS CORP.
  11. Install the left body hinge pillar trim panel. Refer to TRIM REPLACEMENT -- HINGE PILLAR .
scientia non olet · About LEMON Manuals