Removal Procedure

Important:  The ignition switch must be in the OFF position when removing the instrument cluster assembly.

1. Remove the IP cluster trim plate. Refer to TRIM PANEL REPLACEMENT - IP Cluster (Standard Column)  or TRIM PANEL REPLACEMENT - IP Cluster (Standard Column) .
2. Remove the 3 screws which secure the instrument cluster assembly.
   Fig 1: Removing 3 Screws

   Courtesy of GENERAL MOTORS CORP.
3. Disconnect the 4 electrical connectors (2) from the cluster assembly (1).
4. Remove the cluster assembly (1) from the instrument panel assembly.
   Fig 2: Disconnecting 4 Electrical Connectors From Cluster Assembly

   Courtesy of GENERAL MOTORS CORP.