LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Monte Carlo LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Front Cover Cleaning and Inspection

Engine Front Cover Cleaning and Inspection

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Position Sensor
    GM54378Courtesy of GENERAL MOTORS CORP.
  1. Remove the crankshaft position sensor bolts from the engine front cover.
  2. Remove the crankshaft position sensor.
    3. Fig 2: Engine Front Cover
    GM349557Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Cleaning Solvent Caution in Cautions and Notices.
  3. Clean the engine front cover with cleaning solvent.
  4. Inspect the engine front cover sealing surfaces for damage.
  5. Inspect the engine front cover threaded holes.
  6. Repair or replace the engine front cover as necessary.
    7. Fig 3: Crankshaft Position Sensor
    GM54378Courtesy of GENERAL MOTORS CORP.
  7. Install the crankshaft position sensor to the engine front cover.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the crankshaft position sensor bolts. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or the equivalent to the threads.

    Tighten:  Tighten the crankshaft position sensor bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals