LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Monte Carlo LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.4L V6 - VIN (E) (On-Vehicle) >> Repair Instructions >> Valve Stem Oil Seal & Valve Spring - Replacement >> Installation Procedure

Installation Procedure

  1. Install the valve stem oil seal/spring seat.
    • Use a suitable driver.
    • Press over the valve guide boss.
  2. Install the valve spring.
  3. Install the valve cap.
  4. Compress the valve spring with the J 38606  .
  5. Install the valve locks. If necessary, hold the valve locks in place with grease.
  6. Release the valve spring using the J 38606  .
  7. Make sure that the valve locks are seated.
  8. Install the valve rocker arm. Refer to Valve Rocker Arm & Push Rod - Replacement .
  9. Release the air pressure and remove the J 22794  .
  10. Install the spark plug.
scientia non olet · About LEMON Manuals