LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Monte Carlo LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.4L V6 - VIN (E) (On-Vehicle) >> Repair Instructions >> Valve Rocker Arm Cover (Right) - Replacement >> Installation Procedure

Installation Procedure

  1. Install a new right valve rocker arm cover gasket to the valve rocker arm cover.

    Important:  Apply sealant GM P/N 12345739, (Canadian P/N 10953472) or equivalent at the cylinder head to lower intake manifold joint.

  2. Apply sealant at the cylinder head to lower intake manifold joint at the rear of the lower intake manifold (1).

    Important:  Apply sealant GM P/N 12345739, (Canadian P/N 10953472) or equivalent at the cylinder head to lower intake manifold joint.

  3. Apply sealant at the cylinder head to lower intake manifold joint at the rear of the lower intake manifold (1).
  4. Install the right valve rocker arm cover.
  5. Install the valve rocker arm cover bolts. Tighten the bolts to 10 N.m (89 in lbs).
  6. Install the vacuum hose to the grommet in the right valve rocker arm cover.
  7. Install the Ignition coil bracket studs.
  8. Install the ignition coil bracket with coils.
  9. Install the EVAP purge valve.
  10. Connect the vacuum hoses to the EVAP purge valve.
  11. Install the right spark plug wires.
  12. Install the generator bracket.
  13. Install the generator.
  14. Install the drive belt. Refer to Drive Belt Replacement .
  15. Connect the negative battery cable.
scientia non olet · About LEMON Manuals