LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Monte Carlo LS >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 3.4L V6 - VIN (E) (On-Vehicle) >> Repair Instructions >> Engine Mount Bracket - Replacement >> Installation Procedure

Installation Procedure

  1. Install the engine mount bracket to the engine mount.
  2. Install the engine mount upper nuts. Tighten the upper nuts to 47 N.m (35 ft lbs).
  3. Install the engine mount bracket to the oil pan.
  4. Install the bolts which secure the engine mount bracket to the oil pan. Tighten the bracket bolts to 58 N.m (43 ft lbs).
  5. Lower the vehicle.
  6. Lower the engine.
  7. Raise and suitably support the vehicle.
  8. Install the right engine splash shield.
  9. Install the right front wheel and tire.
  10. Connect the three-way catalytic converter pipe to the right exhaust manifold.
  11. Lower the vehicle.
  12. Install the engine mount struts.
  13. Install the throttle body air inlet duct.
  14. Connect the battery ground cable.
scientia non olet · About LEMON Manuals