LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Malibu LS >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension General Diagnosis >> Diagnostic Information >> Ride Diagnosis - Too Hard

Ride Diagnosis - Too Hard

  1. Did you review the General Description and perform the necessary inspections? If so, go to next step. If not, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS  .
  2. Verify that the ride is too hard. Does the vehicle ride normally? If so, then system is okay. If not, go to next step.
  3. Inspect the tires for the proper inflation pressure. Is the tire inflation pressure correct? If so, go to step  5 . If not, go to next step.
  4. Inflate the tires to the correct pressure. After repair, go to next step.
  5. Inspect the struts and springs for wear or damage. Refer to STRUTS OR SHOCK ABSORBERS ON-VEHICLE TESTING  . Are any of the components the worn or damaged? If so, go to next step. If not, go to step  7 .
  6. Replace all of the worn or damaged components. For any strut component replacement, refer to STRUT, STRUT COMPONENT AND/OR SPRING REPLACEMENT in FRONT SUSPENSION or STRUT DISASSEMBLE/ASSEMBLE REPAIR in REAR SUSPENSION. After repair, go to next step.
  7. Operate the system in order to verify the repair. Did you correct the condition? If so, then system is okay. If not, go to step  3 .