Installation Procedure
- Install the IP carrier (1) to the cross vehicle beam (6).CAUTION: Refer to FASTENER NOTICE .
- Install the screws (2, 3, 4) connecting the IP carrier (1) to the cross vehicle beam (6).
Tighten
Tighten the screws to 2 N.m (18 lb in).
- Install the ashtray.
- Install the center console. Refer to Console Replacement .
- Connect the outboard electrical connectors to the IP wiring harness junction blocks.
- Install the ignition switch bolts. Refer to Ignition Switch Replacement .
- Install the radio and the remote cassette player, if needed. Refer to RADIO REPLACEMENT and REMOTE CASSETTE PLAYER REPLACEMENT .
- Install the HVAC controls. Refer to HVAC MODULE ASSEMBLY .
- Install the IP cluster. Refer to Instrument Panel Cluster (IPC) Replacement .
- Install the IP cluster trim plate. Refer to Trim Panel Replacement - IP Cluster .
- Install the IP accessory trim plate. Refer to Trim Plate Replacement - IP Accessory .
- Install the multifunction switch. Refer to MULTIFUNCTION TURN SIGNAL SWITCH .
- Install the steering wheel. Refer to STEERING WHEEL .
- Install the passenger side SIR inflator module. Refer to AIR BAG MODULES .
- Install the left and right sound insulators. Refer to Closeout/Insulator Panel Replacement - Right and Closeout/Insulator Panel Replacement - Left .
- Install the outer trim covers. Refer to Instrument Panel (IP) Outer Trim Cover Replacement .
- Install the IP compartment. Refer to Compartment Replacement - IP .
- Install the defroster grille. Refer to Defroster Grille Replacement .
- Enable the SIR system. Refer to ACTIVATING SYSTEM .