Installation Procedure
- Connect the electrical connection to the IP compartment lamp switch.
- Install the IP compartment to the IP carrier.
CAUTION: Refer to FASTENER NOTICE .
- Install the IP compartment screws to the underside of the instrument panel compartment door.
Tighten
Tighten the screws to 2 N.m (18 lb in).
- Open the IP compartment door and install the remaining IP compartment screws inside the pocket.
Tighten
Tighten the screws to 2 N.m (18 lb in).
- Enable the SIR system. Refer to ACTIVATING SYSTEM .