Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Push Rods

Courtesy of GENERAL MOTORS CORP.

Coat the ends of the push rods using Engine Oil Supplement (EOS) GM P/N 1052367 (Canadian P/N 992869) or the equivalent.

IMPORTANT: The intake valve push rods measure 144 mm (5.75 in) in length.
The exhaust valve push rods measure 152.5 mm (6.0 in) in length.

Install the push rods in their original location.

Fig 2: View Of Valve Rocker Arm

Courtesy of GENERAL MOTORS CORP.

Coat the rocker arm friction surfaces using Engine Oil Supplement (EOS) GM P/N 1052367 (Canadian P/N 992869) or the equivalent.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the valve rocker arm bolts.
Tighten:
1. Tighten the bolts to 32 N.m (24 lb ft).
Install the valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left or Valve Rocker Arm Cover Replacement - Right .