LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> On-Vehicle Repair instructions >> Valve Rocker Arm Cover Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cylinder Head To Lower Intake Manifold Joint (Front)
    GM190589Courtesy of GENERAL MOTORS CORP.
  1. Install a new right valve rocker arm cover gasket to the valve rocker arm cover.
    2. IMPORTANT: Apply sealant GM P/N 12346141, (Canadian P/N 10953433) or equivalent at the cylinder head to lower intake manifold joint.
  2. Apply sealant at the cylinder head to lower intake manifold joint at the rear of the lower intake manifold (1).
    3. Fig 2: Identifying Cylinder Head To Lower Intake Manifold Joint
    GM190588Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Apply sealant GM P/N 12346141, (Canadian P/N 10953433) or equivalent at the cylinder head to lower intake manifold joint.
  3. Apply sealant at the cylinder head to lower intake manifold joint at the rear of the lower intake manifold (1).
    4. Fig 3: Right Valve Rocker Arm Cover
    GM61834Courtesy of GENERAL MOTORS CORP.
  4. Install the right valve rocker arm cover.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the valve rocker arm cover bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Install the vacuum hose to the grommet in the right valve rocker arm cover.
  7. Install the Ignition coil bracket studs.
  8. Install the ignition coil bracket with coils. Refer to IGNITION COILS .
  9. Install the EVAP purge valve.
    10. Fig 4: Vacuum Hoses To EVAP Purge Valve
    GM261279Courtesy of GENERAL MOTORS CORP.
  10. Connect the vacuum hoses to the EVAP purge valve.
  11. Install the right spark plug wires.
  12. Install the generator bracket. Refer to Generator Bracket Replacement in Engine Electrical.
  13. Install the generator. Refer to Generator Replacement (3.4L) in Engine Electrical.
  14. Install the drive belt. Refer to Drive Belt Replacement .
  15. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals