LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> On-Vehicle Repair instructions >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Lifters & Lifter Guides
    GM54701Courtesy of GENERAL MOTORS CORP.
  1. Coat the valve lifters using prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent.
  2. Install the valve lifters in their original locations.
  3. Install the lifter guide.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or the equivalent to the lifter guide bolts and install the bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Install the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
  6. Install the lower intake manifold. Refer to Intake Manifold Replacement - Lower .
  7. Install the valve rocker arm cover. Refer to Valve Rocker Arm Cover Replacement - Left  or Valve Rocker Arm Cover Replacement - Right .
  8. Inspect for leaks.
scientia non olet · About LEMON Manuals