LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> On-Vehicle Repair instructions >> Oil Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Rotate the driveshaft as necessary in order to obtain the engagement with the oil pump drive unit.
    Fig 1: Removing/Installing Oil Pump & Oil Pump Drive Shaft
    GM190530Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump driveshaft and the oil pump.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the oil pump bolt.

    Tighten:  Tighten the bolt to 41 N.m (30 lb ft).

  3. Install the oil pan. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals