LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> On-Vehicle Repair instructions >> Oil Pump Drive Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Pump Drive, Bolt & Clamp
    GM190531Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump drive seal. Coat the seal or bore in the engine block with engine oil.
  2. Coat the drive gear on the drive with prelube GM P/N 1052367 (Canadian P/N 992869) or the equivalent for the full 360 degrees.
  3. Install the oil pump drive.
  4. Install the oil pump drive clamp.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the oil pump drive clamp bolt.

    Tighten:  Tighten the bolt to 36 N.m (27 lb ft).

  6. Install the fuel feed and the fuel return pipes to the fuel injector rail. Refer to FUEL RAIL & INJECTORS .
    7. Fig 2: Fuel Pipe Clip & Bolt
    GM190512Courtesy of GENERAL MOTORS CORP.
  7. Install the fuel pipe clip to the fuel lines.
  8. Install the fuel pipe clip bolt.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in).

  9. Install the upper intake manifold. Refer to Intake Manifold Replacement - Upper .
scientia non olet · About LEMON Manuals