Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Oil Level Indicator & Oil Level Indicator Tube

Courtesy of GENERAL MOTORS CORP.

Clean the oil level indicator tube.
Apply sealant around the oil level indicator tube 12.7 mm (0.50 in) below the bead. Use GM sealant P/N 12346286 (Canadian P/N 10953472) or the equivalent.
Install the oil level indicator tube into the engine block.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the oil level indicator tube bracket bolt.
Tighten: Tighten the bolt to 25 N.m (18 lb ft).
Install the oil level indicator.
Install the spark plug wire to the number 6 cylinder spark plug.