LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> On-Vehicle Repair instructions >> Engine Mount Strut Bracket Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
    2. Fig 1: Engine Mount Strut - Right
    GM462746Courtesy of GENERAL MOTORS CORP.
  2. Remove the right engine mount strut from the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right .
    3. Fig 2: Engine Mount Strut Bracket Bolt - Right
    GM190592Courtesy of GENERAL MOTORS CORP.
  3. If equipped with oil cooler, remove the oil cooler pipe bracket bolt from the right engine mount strut bracket.
  4. Reposition the air conditioning compressor. Refer to Compressor Replacement (3.4L) in HVAC.
    5. Fig 3: Engine Mount Strut Bracket - Right
    GM54655Courtesy of GENERAL MOTORS CORP.
  5. Remove the vertical bolt from the right engine mount strut bracket.
  6. Remove the right engine mount strut bracket.
scientia non olet · About LEMON Manuals