LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> On-Vehicle Repair instructions >> Engine Mount Strut Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount Strut Bracket - Right
    GM54655Courtesy of GENERAL MOTORS CORP.
  1. Position the right engine mount strut bracket over the pin locator.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the vertical bolt through the right engine mount strut bracket to the cylinder head.

    Tighten:  Tighten the engine mount strut bracket bolt to 50 N.m (37 lb ft).

  3. Install the air conditioning compressor. Refer to Compressor Replacement (3.4L) in HVAC.
    4. Fig 2: Engine Mount Strut Bracket Bolt - Right
    GM190592Courtesy of GENERAL MOTORS CORP.
  4. If equipped with oil cooler, install the oil cooler pipe bracket bolt to the right engine mount strut bracket.

    Tighten:  Tighten the oil cooler pipe bracket bolt to 10 N.m (89 lb in).

    5. Fig 3: Engine Mount Strut - Right
    GM462746Courtesy of GENERAL MOTORS CORP.
  5. Install the right engine mount strut to the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right .
  6. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals