LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> On-Vehicle Repair instructions >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Mount Upper Nuts
    GM96010Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount to the engine mount bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount upper nuts.

    Tighten:  Tighten the upper nuts to 43 N.m (32 lb ft).

    3. Fig 2: Engine Mount, Engine Mount Bracket & Bolts
    GM96007Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount bracket with the engine mount to the oil pan.
  4. Install the bolts which secure the engine mount bracket to the oil pan.

    Tighten:  Tighten the bolts to 58 N.m (43 lb ft).

  5. Lower the vehicle.
  6. Lower the engine.
  7. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    8. Fig 3: Engine Mount Lower Nuts
    GM462775Courtesy of GENERAL MOTORS CORP.
  8. Install the engine mount lower nuts.

    Tighten:  Tighten the lower nuts to 43 N.m (32 lb ft).

  9. Install the right engine splash shield. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
  10. Install the right front wheel and tire. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  11. Connect the three-way catalytic converter pipe to the right rear exhaust manifold. Refer to Catalytic Converter Replacement (3.4L) in Engine Exhaust.
  12. Lower the vehicle.
  13. Remove the engine support fixture.
  14. Install the engine mount struts. Refer to Engine Mount Strut Replacement - Left  and to Engine Mount Strut Replacement - Right .
  15. Install the throttle body air inlet duct.
  16. Connect the battery ground cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals