Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Install the engine mount bracket to the engine mount.
- Install the engine mount upper nuts.
Tighten: Tighten the upper nuts to 43 N.m (32 lb ft).
- Install the engine mount bracket to the oil pan.
- Install the bolts which secure the engine mount bracket to the oil pan.
Tighten: Tighten the bracket bolts to 58 N.m (43 lb ft).
- Lower the vehicle.
- Lower the engine.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Install the right engine splash shield. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
- Install the right front wheel and tire. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Connect the three-way catalytic converter pipe to the right exhaust manifold. Refer to Catalytic Converter Replacement (3.4L) in Engine Exhaust.
- Lower the vehicle.
- Install the engine mount struts. Refer to Engine Mount Strut Replacement - Left and to Engine Mount Strut Replacement - Right .
- Install the throttle body air inlet duct.
- Connect the battery ground cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.