LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pan Cleaning and Inspection

Oil Pan Cleaning and Inspection

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cleaning Oil Pan
    GM314537Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil level sensor bolt, if equipped.
  2. Remove the oil level sensor, if equipped.
    3. CAUTION: Refer to Cleaning Solvent Caution in Cautions and Notices.
  3. Clean the oil pan in solvent. Remove all sludge and debris from the bottom of the oil pan.
  4. Inspect the oil pan sealing surfaces for damage.

    Replace the oil pan if necessary.

  5. Install the oil level sensor, if equipped.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the oil level sensor bolt, if equipped.

    Tighten:  Tighten the oil level sensor bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals