LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Manifold Removal - Upper

Intake Manifold Removal - Upper

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: MAP Sensor Electrical Connector, Bracket & Bolts
    GM813501Courtesy of GENERAL MOTORS CORP.
  1. Remove the MAP sensor electrical connector.
  2. Remove the MAP sensor bolts.
  3. Remove the MAP sensor from bracket.
  4. Remove the MAP sensor bracket and bracket bolt.
    5. Fig 2: EGR Valve, Bolt & Gasket
    GM511767Courtesy of GENERAL MOTORS CORP.
  5. Remove the EGR valve pipe and bolt from the EGR valve.
  6. Remove the EGR valve bolts.
  7. Remove the EGR valve and gasket.
    8. Fig 3: Vacuum Harness Assembly
    GM523301Courtesy of GENERAL MOTORS CORP.
  8. Remove the vacuum harness assembly.
    9. Fig 4: Accelerator Cable Bracket & Bolts
    GM813507Courtesy of GENERAL MOTORS CORP.
  9. Remove the accelerator cable bracket and bracket bolts.
    10. Fig 5: View Of Upper Intake Manifold, Gaskets, Bolts & Stud
    GM813509Courtesy of GENERAL MOTORS CORP.
  10. Remove the purge valve bracket bolt, hose and valve assembly.
  11. Remove the throttle body bolts.
  12. Remove the throttle body and gasket.
  13. Remove the upper intake manifold bolts.
  14. Remove the upper intake manifold and gaskets.
scientia non olet · About LEMON Manuals