Test H: Driver Information Center (DIC) Compass Inaccurate Or Cal Is Displayed
- Perform driver information center system diagnostic system check. See DRIVER INFORMATION CENTER SYSTEM DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM. If driver information center system diagnostic system check has been performed, go to next step.
- Observe DIC. If compass is inaccurate, or CAL or C is displayed, go to next step. If compass is not inaccurate, or CAL or C is not displayed, check for intermittent problem. See DIAGNOSING INTERMITTENTS . Repair or replace as necessary. After repair, go to step 8 .
- Turn ignition switch to RUN position. Observe DIC. If compass display is not blank, go to next step. If compass display is blank, go to step 7 .
- If compass displays CAL, go to next step. If compass does not display CAL, go to step 6 .
- Perform compass calibration procedure. See COMPASS CALIBRATION under PROGRAMMING. If compass operation is okay, go to step 8 . If compass operation is not okay, go to next step.
- Perform compass magnetic variation adjustment procedure. See COMPASS MAGNETIC VARIATION ADJUSTMENT under PROGRAMMING. If compass operation is okay, go to step 8 . If compass operation is not okay, go to next step.
- Replace DIC and calibrate compass. See DRIVER INFORMATION CENTER (DIC) under REMOVAL & INSTALLATION. Go to next step.
- Operate system to verify repair. If system operates normally, repair is complete. If system does not operate normally, return to step 2 .