LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Park Brake Pedal Assembly >> Removal

Park Brake Pedal Assembly: Removal

  1. Remove the left side instrument panel insulator. Remove the left carpet retainer. Pull back the carpet for access. Raise and suitably support the vehicle. Relieve cable tension from the park brake system at the equalizer.
  2. Disconnect the front cable from the rear cable at the connector clip. Lower the vehicle. Disconnect the electrical connector at the parking brake switch. Remove the 3 park brake pedal assembly retaining nuts from the body mounting studs.
  3. Remove the retaining clip and disconnect the parking brake cable from the park brake pedal assembly. Use the Parking Brake Cable Release Tool in order to remove the cable from the pedal assembly. Remove the park brake pedal assembly.
scientia non olet · About LEMON Manuals