Removal (Rear)
NOTE:
Required Tools: Parking Brake Cable Release Tool (J-37043).
- Raise and suitably support the vehicle. Relieve the park brake cable tension at the equalizer.
- Disconnect the front cable from the rear cable that is to be replaced.
- For the right rear cable, disconnect the cable from the clip.
- For the left rear cable, fully remove the equalizer nut from the equalizer stud, which is part of the left rear cable.
- Disconnect the retainer that holds the cable to the support bracket. Use the Parking Brake Cable Release Tool to release the retainer.
- Disconnect the park brake cable from the actuator lever. Remove cable retaining pin from the support bracket and remove the park brake cable.