LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Park Brake Actuators >> Installation

Park Brake Actuators: Installation

  1. Assemble the actuator to the park brake shoe. Install the park brake shoe and actuator onto the backing plate.
  2. Position the park brake shoe, actuator, and backing plate over the rear hub. Install the park brake cable bracket and the 2 retainers.
  3. Tighten the bracket retainers to specification. See TORQUE SPECIFICATIONS  .
  4. Install the rear hub. The rear hub, backing plate, park brake cable bracket, and park brake actuator will be installed as an assembly.
  5. Install and connect the rear park brake cable to the bracket at the rear wheel. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel.
  6. Install the rear rotor. See BRAKE ROTORS  . Install the rear caliper bracket. See BRAKE CALIPER BRACKETS  .
  7. Install the rear tire and wheel assemblies. Adjust the park brake system. See PARKING BRAKE ADJUSTMENT  in PARK BRAKE SYSTEM under ADJUSTMENTS & INSPECTIONS. Lower the vehicle.
scientia non olet · About LEMON Manuals