LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala LS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Adjustments & Inspections >> Park Brake System >> Park Brake Shoe Inspection

Park Brake Shoe Inspection

  1. Raise and support the vehicle. Remove the tire and wheel.
  2. Remove the rear brake caliper bracket with the rear brake caliper. See BRAKE CALIPER BRACKETS  under REMOVAL & INSTALLATION.
  3. Remove the rear brake rotor. See BRAKE ROTORS  under REMOVAL & INSTALLATION.
  4. Inspect the park brake shoe and lining. If it exhibits any of the following conditions, then it requires replacement:
    • Excessive wear indicated by the park brake lining being worn down to the shoe.
    • Brake lining cracking.
    • Oil or fluid contamination of the brake lining.
  5. Install the rear brake rotor. See BRAKE ROTORS  under REMOVAL & INSTALLATION.
  6. Install the rear brake caliper with the rear brake caliper bracket. See BRAKE CALIPER BRACKETS  under REMOVAL & INSTALLATION.
  7. Install the tire and wheel. Lower the vehicle.
scientia non olet · About LEMON Manuals